Molift Air 300, Техническое руководство

Страница: 26 / 36

25
Molift Air / www.molift.com
PCB (Printed Circut board)
The lifter has a PCB (Printed Circut board).
1. Battery cable
2. Motor Cable
3. Temperature battery
4. Brake
5. Emergency lowering
6. DIN 13 contact (Hand control)
7. LED/DIN
8. Sensors
9. 20 Amp fuse
10. TES (to Emergency stop)
11. EDT (Emergency detect)
12. FES (From Emergency stop)
13. Propulsion motor
Refer to electric diagram for more details.
Remove PCB
1. Open sidecover, disconnect battery
2. Remove hand control cover and disconnect
hand control
3. Disconnect all wires attached to the PCB
4. Remove both screws (T20) at bottom of PCB.
5. Flip the PCB out
Install new PCB
1. Molift Service Tool must be used to copy set-
tings from old Card to the new card.
2. Use molift Service tool and install factory set-
tings to PCB. Refer to User Manual for Molift
Service Tool.
3. Disconnect all cables. Remove old PCB, and
mount new PCB in lifter.
Check after installation
All buttons and functions are working
Perform and fill out Safety checklist
after service and repair
PCB Parts
Article no.
2520112 PCB
4
9
10
11
12
13
1
3
5
2
7
8
6