Molift Air 300, Техническое руководство

Страница: 17 / 36

16
Molift Air / www.molift.com
Remove Bottom Plate
The bottom cover are locked with snap hooks.
Open sidecover to access the snap hooks, and
push them out from inside.
Change Lower cover
1. Remove Sidecovers, disconnect battery
2. Release all cables from cable clips.
3. Remove battery clamp (hex key 5mm) and
battery.
4. Remove hand control cover and hand control.
5. Remove suspension coupling.
6. Remove bottom plate.
7. Remove Remove Emergency stop relay and
button.
8. Remove Angle sensor plastic part, and micro
switch.
9. Remove the 2 screws from PCB (Torx 20)
10. Remove the 4 Screws (hex key 4mm) from
motor/gear house holding the lower cover, 2
screws on each side.
11. Remove the 4 screws (Torx 20) in each corner
of the lower cover
12. Cut the wire for angle sensor micro switch.
13. Cut the wire for LED lights and remove cover.
14. Pull wires for Led lights and microswitch
through the new cover, and solder wires. Use
heat shrink tube to isolatee on all wires.
15. Glue led indicators to lower cover and insert
angle sensor microswitch in slot.
16. Remount all parts as described (pt. 1-11) in
reverse order.
Check after installation
Make sure all covers are attached properly
and there are no loose parts.
Run the lifter, and pull band sideways to
activate angle sensor. The lifter should stop
lifting when angle sensor activates.
Perform and fill out Safety checklist
after service and repair
Cover Parts
Article no.
2510005 Side Cover Tegn. (20-104)
2510004 Upper Cover Tegn. (20-101)
2510000
Lower cover Tegn (20-102)
2510008 Bottom plate Tegn. (20-103)
2510061
Hand control cover (20-136)
Led lights
2510007 Microbryter Series 1050 Wlfa
35-830-55