Molift Air 300, Техническое руководство

Страница: 22 / 36

21
Molift Air / www.molift.com
Replacing Lifting Band
Remove lifting band
1. Run the lifter until the lifting band is run out
completely. Pull the band while pushing down
button (the band must be tensioned or band
slack sensor activates)
2. Open sidecover
3. Remove lid from gear house by removing 4
screws (PH2) to access the drum.
4. Run lifter and position bolt at approx 15° to
the right. (5 o’clock)
5. Activate emergency stop
6. Disconnect battery
7. Remove bolt with Large flat screwdriver.
8. Pull out the lifting band
Install new Lifting Band
1. Insert new lifting band. Make sure band is
inserted on th correct side of the guiding
drum.
2. Align lifting band with hole, and insert bolt.
Tighten the bolt properly.
3. Mount the lid (4 PH2 screws with washer).
4. Reconnect battery and mount the side cover.
5. Push UP button on handcontrol to drive band
in on the drum.
Check after installation
Run the lifting band in and out completely,
make sure band goes up when pushing up
button.
Test lifter with one lifting cycle with SWL.
Perform and fill out Safety checklist
after service and repair
Lifting Band Parts
Article no.
2510063 Lifting Band Molift Air