Molift Air 300, Техническое руководство

Страница: 18 / 36

17
Molift Air / www.molift.com
Hand control
Hand control
The Hand control has 2 buttons for lifting and
lowering, or 4 buttons if the hoist is equipped
with propulsion. The Hand control has an indica-
tor light that will illuminate when battery level is
low and the lifter requires charging
The Hand control has four charging probes on the
back for charing through wall mounted charger, or
no probes if lifter has In Rail Charging (IRC).
Hand Control Clip
Hand control clip is snap on and can be replaced
by lifting snap hook (use a plastic pry tool) and
push clip downwards.
Hand control with four charging probes.
Remove Hand control
1. Unscrew both screws (Torx 20) and remove
cover
2. Unplug hand control
Install Hand control
1. Connect hand control
2. Attach cover and tighten both screws properly
(Torx 20)
Check after installation
All buttons and functions are working
The cover shall function as a cabel clamp.
Pull the hand control cable slightly to makes
sure the cover is properly fastened.
Perform and fill out Safety checklist
after service and repair
Hand Control Parts
Article no.
2510061 Cover Handcontrol
2017002 Hand Control 2 buttons w/charging
2019004 Hand Control 4 buttons w/charging
0440002 Hand Control 2 buttons
Hand Control 4 buttons
0440004 Replaceable hook for Molift hand
controls