Molift Air 300, Техническое руководство

Страница: 24 / 36

23
Molift Air / www.molift.com
Lifting Motor/Gear House
Remove lifting motor/gearhouse.
1. Activate emergency stop
2. Remove both side covers
3. Disconnect Battery power cable and tempera-
ture sensor, remove battery clamp.
4. Disconnect Power cable to motor from PCB.
5. Remove both Quick release buttons for trolley.
6. Remove the 4 screws (Torx 20) in each corner
of the upper cover
7. Remove both microswitches (2x PZ1 screws on
both microswitches).
8. Remove the 4 Pan Head Screws (Hex key 4mm)
from motor/gear house holding the lower
cover, 2 screws on each side motor gear unit.
9. Dismantle suspension coupling and lifting
motor can be removed.
10. Install new motor/gear in reverse order.
Change Brake
1. Activate emergency stop
2. Remove both side covers
3. Disconnect battery
4. Remove set screw on Hexagon sleeve and pull
it off.
5. Unscrew bolts holding brake and replace the
brake.
6. Assemble in reverse order.
Parts
Article no.
2510001 Motor/Gear Molift Air
1220194 Extension Spring 0,5x8x25
2510145 Brake 24V DC
2510137 Allen Key Hex Socket 6mm
2510136 Allen Key Hex Straight 6mm x 100
2510146 Hexagon sleeve
1431011 Set screw DIN 914 M4x6 Elzn
Check after installation
All buttons and functions are working
Run the lifter, and pull band sideways to
activate angle sensor. The lifter should stop
lifting when angle sensor activates.
Perform and fill out Safety checklist
after service and repair