43
Wing Hardware:
Gather the following painted cast metal parts for the wings: Four (4) Sets of
Forward
Spar
Cable Anchor Points
(upper and lower); four (4) Sets of
Rear Spar
Cable Anchor Points
(upper and lower); two (2)
Rear Spar
Eye Bolts
;
two (2)
0-80 Washers
; two (2) 0-80
Nuts
; six
Compression Struts
; twelve (12)
Compression Strut Bolt Sets
; two (2)
Aluminum Step Plates
(Photo etched); ten (10)
Turnbuckles
(holes drilled 1/32”).
Place the
Left
and
Right Wings
on their building patterns. Locate and glue the three (3)
Compression
Struts
in place and shims may be needed to compensate for the
Strut
fit due to variations in building. If
shims are needed, add them at the
Rear Spar
end of the
Strut
. Once all the
Compression Struts
are
in place glue the
Nut Sets
on the other side of the spars as seen in the picture on the next page.
Using the building board as reference, glue in place the
Cable Anchor Points
by adding the lower part
first and then the upper noting the orientation towards the
Fuselage
as seen on the
Assembled Views
and Details
Plan Sheet
. Then drill 1/32” holes in the locations for the
Eye Bolts
on the
Rear Spar
.
Insert the
Eye Bolts
into the holes with the eye facing forward then add
0-80 Washers
first then
0-80
Nuts
onto the
Eyebolt Shafts
and glue in place.
Once all the
Cable
Anchor Points
glue has set then drill the holes in them to make sure they are clean
to receive the
Cable Lines
both top and bottom.
