35
Prime paint the two (2)
Ammo Can Chutes
; left and right a
Steel Color
. Paint the
Bullet Belts
the
colors as seen below. Glue a six (6) inch length of
Black Line
into each of the drilled holes in the
bottom of the
Receivers.
See the picture below.
Now to install the
Machine Guns
and due to tight fits the best sequence for installation is to install the
left gun first down the center and rolling into the location holes on the
Machine Gun Mount
while also
inserting the
Black Line
down between the
Ammo Cans
to be later attached to the
Joystick
.
DO
NOT
GLUE
the gun into the location holes yet. Carefully fit the left
Ammo Chute
down in place into the rear
Spent Ammo Can
between the
Mast
and insert the tab into the open slot in the side of the
Machine
Gun
and add a drop of thin CA to the tab only. Next very slowly bend and form one
Bullet Belt
to fit the
left gun indexed into the open slot on the right side of the
Receiver
trimming off the white gun belt to
have one bullet into the
Receiver
.
Note:
the gun belt extensions are for easier molding and bending
and be cut off after forming. This
Bullet Belt
could interfere with the right
Ammo Chute
if the bend is
not tight enough. Set the formed
Bullet
Belt
aside for now, the space is needed to get the right
Machine Gun
in place. Fit the right
Machine Gun,
while also inserting the
Black Line
down between
the
Ammo Cans
to be later attached to the
Joystick
then in place by carefully fitting onto the location
holes in the
Machine Gun Mount.
Fit and glue in place the
Right Ammo Chute
per the left side.
Slowly bend and form the
Bullet Belt
to fit the right gun indexed into the open slot on the right side of
the
Receiver.
With the
right
Ammo Chute
in place and both guns setting in their location holes, now
form and cut to length needed the two (2)
Interrupter
Linkage Rods
from the levers to the hole in front
of the
Receiver
. Index the bent ends into the
Lever
holes and then back to the
Receiver
holes and
