Mocom millenium B2, Руководство по эксплуатации, Страница: 43 / 96

8. PROGRAM SELECTION
38
PROGRAM
SELECTION
INTRODUCTION
Program selection is fundamental for a successful sterilization process.
Since each instrument, or material in general, has different shape, consistency and properties,
it is important to identify the most suitable program for it, both for preserving its physical
characteristics (avoiding or, at any rate, limiting alterations) as well to guarantee the most
effective sterilization.
NOTE
A
GUIDE TO SELECTING THE MOST SUITABLE PROGRAM FOR THE LOAD IS PROVIDED IN
A
PPENDIX
B (P
ROGRAMS
).
PROCEDURE
Power-on the device as described in the Chapter, “First Start-Up”.
NOTE
I
F A PASSWORD HAS BEEN ENABLED
(
SEE THE
C
HAPTER
C
ONFIGURATION
- S
ETTING
THE PASSWORD
),
YOU WILL BE ASKED TO ENTER THE ACCESS CODE
:
I N S E R T P A S S W O R D
↵ t o e n t e r
Ç t o e x i t
Enter the password using the + and – keys. Confirm with the
↵
key.
The display does not offer any active preselection.
The device is waiting for the user to select a program.
Press the PROGRAM SELECTION key one or more times until you reach the desired
program (1, 2, 3 or 4, also shown on the upper left of the display).
NOTE
W
HEN THE SELECTION KEY IS PRESSED
,
THE FIRST STERILIZATION PROGRAM PROPOSED
IS THE ONE USED FOR THE LAST CYCLE EXECUTED
.
In the two lines above the description, the display shows the description of the selected
program and the type of drying set and, below, the set-point values for the temperature (°C),
pressure (bar) and time (mm:ss) of the cycle selected. By way of example, the display shows:
1
1 3 4 ° C P O R O U S
N O R M A L D R Y I N G
1 3 4 . 0 ° C ( B )
2 . 1 0 b a r 0 4 : 0 0
After a brief interval, the display changes and shows the temperature and pressure values of
the chamber, with the current date and time.
1
1 3 4 ° C P O R O U S
N O R M A L D R Y I N G
1 0 1 . 0 ° C 3 0 / 0 8 / 0 2
0 . 0 1 b a r 1 8 : 1 3 : 0 5
To cancel the selection, press ESC
Ç
on the control panel.