Mitsubishi MOTORS Outlander PHEV 2018, Руководство пользователя

Страница: 225 / 457

Blind Spot Warning (BSW) (with Lane Change Assist) (if so equipped)
5-104 Features and controls
5
N00593500066
When the BSW switch is pressed while the
operation mode of the power switch is ON,
the BSW indicator light in the instrument
WARNING
 In certain situations, the BSW may not
detect a vehicle in the detection areas or
the detection may be delayed. Some of
these include;
• When a small motorcycle or a bicycle is
behind your vehicle.
• When a vehicle is traveling alongside of
your vehicle at nearly the same speed for
prolonged periods of time.
• When the heights of the next lane and
your lane are different.
• Immediately after the BSW has been
turned on.
• Immediately after the power switch is
turned on.
• Under adverse weather conditions, such
as rain, snow, strong winds or sand
storms.
• When your vehicle becomes too close to
another vehicle.
• While multiple vehicle are overtaking
your vehicle.
• When driving near a pot hole and tram-
line.
• When a surrounding vehicle or an
oncoming vehicle is splashing water,
snow or dirt.
• When driving on a curve including the
beginning and the end of the curve.
• When driving on a road with alternating
up and down steep slopes.
• When driving on a bumpy or rough road.
• When the rear of your vehicle is weighed
down or your vehicle is leaning to the
right or left due to the weight of passen-
gers and luggage or the improper adjust-
ment of tire pressure.
• When the bumper surface around the
sensor is covered with dirt, snow and ice,
etc.
WARNING
• When the sensor is extremely hot or cold
(while the vehicle is parked for a long
period of time under a blazing sun or in
cold weather).
• When a bicycle carrier or accessory is
installed to the rear of the vehicle.
CAUTION
 To maintain proper performance of the BSW,
follow the instructions below.
• Always clean the bumper surface around
the sensor.
• Avoid impacting the sensor or its surround-
ing area.
• Do not put a sticker on the sensor or its sur-
rounding bumper surface.
• Do not paint the sensor or its surrounding
bumper surface.
• Do not modify the sensor or its surrounding
area.
 If the bumper has experienced an impact, the
sensor may have been damaged and the BSW
may not function properly. Have the vehicle
inspected at a certified Mitsubishi EV dealer.
To operate
WARNING
BK0254400US.book 104 ページ ２０１７年８月１０日 木曜日 午後１時５０分