Mitsubishi MOTORS Eclipse Cross 2019, Руководство пользователя, Страница: 99 / 602

Installing a child restraint sys-
tem to a 3-point type seat belt
(with emergency locking mech-
anism)
CAUTION
l
Do not sit in the centre seating position of
the rear seat when installing a child restraint
system on the left side of the rear seat.
Because the child restraint interferes with
the seat belt, you cannot fasten the seat belt
correctly.
To install
1. Put a child restraint system on the seat in
which you wish to install it, and remove
the head restraint from the seat.
Refer to “Head restraints” on page 4-05.
CAUTION
l Do not remove the head restraint when in-
stalling a booster cushion.
2. When installing a child restraint system
in the front passenger seat or rear seat,
adjust the seat slide to its most rearward
position.
3. Route the belt through the child restraint
according to the child restraint system
manufacturer’s instructions, then insert
the latch plate into the buckle.
4. Use the locking clip to completely elimi-
nate any slackness.
WARNING
l
For some types of child restraint, the lock-
ing clip (A) should be used to help avoid
personal injury during a collision or sud-
den manoeuvre.
It must be fitted and used in accordance
with the child restraint manufacturer’s
instructions.
The locking clip must be removed when
the child restraint is removed.
5. If your child restraint system has a sup-
port leg, make sure that there is a sup-
port leg at the stable position on the
floor.
6. Before putting the child in the restraint,
push and pull the restraint in all direc-
tions to be sure it is secure. Do this be-
fore each use.
Child restraint
4-25
OGKE20E1
Seats and seat belts
4