Mitsubishi MOTORS Eclipse Cross 2019, Руководство пользователя

Страница: 42 / 602

To extend
Unlocking the doors and tailgate using the
UNLOCK switch (2), the outside rear-view
mirrors are extended automatically.
NOTE
l
Functions can be modified as stated below.
Please consult a MITSUBISHI MOTORS
Authorized Service Point.
In a vehicle equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi-Communication System (MMCS), it
is possible to change the setting by means of
screen operations.
Refer to the separate owner’s manual for de-
tails.
• Automatically extend when the driver’s
door is closed and the ignition switch is
turned to the “ON” position or the opera-
tion mode is put in ON.
In addition, automatically retract when the
ignition switch is turned to the “LOCK”
or “ACC” position or the operation mode
is put in OFF or ACC, and the driver’s
door is then opened.
• Automatically extend when the vehicle
speed reaches approximately 30 km/h
(16 mph).
• Deactivate the automatic extension func-
tion.
Setting of door and tailgate un-
lock function (except for vehi-
cles equipped with a Dead
Lock System)
The door and tailgate unlock function can be
set to the following two conditions.
Each time the door and tailgate unlock func-
tion is set, a chime will sound to tell you the
condition of the door and tailgate unlock
function.
Number of
chimes
Condition
One chime
When the UNLOCK switch
(2), driver’s or front pas-
senger’s door lock/unlock
switch, or tailgate open
switch is pressed one time,
all doors and the tailgate un-
lock. [Factory setting]
Two chimes
When the UNLOCK switch
(2) or the driver’s door lock/
unlock switch is pressed one
time, only the driver’s door
unlocks. When the UN-
LOCK switch or the driver’s
door lock/unlock switch is
pressed two times in succes-
sion, all doors and the tail-
gate unlock.
1. Turn the ignition switch to the “LOCK”
position and then remove the key (ex-
cept for vehicles equipped with the key-
less operation system), or put the opera-
tion mode in OFF (vehicles equipped
with the keyless operation system).
2. Place the lamp switch in the “AUTO”
position, and leave the driver’s door
open.
3. Perform the following steps. Steps ii to
iv should be completed within 8 sec-
onds.
Step i:
Press and hold the LOCK switch (1) for 4 to
8 seconds.
Step ii:
While holding the LOCK switch (1), press
the UNLOCK switch (2).
Step iii:
While holding the UNLOCK switch (2), re-
lease the LOCK switch (1).
Keyless entry system
3-06
OGKE20E1
Locking and unlocking
3