Mitsubishi MOTORS Eclipse Cross 2019, Руководство пользователя

Страница: 218 / 602

CAUTION
• On vehicles equipped with M/T, do not
move the gearshift lever to a position oth-
er than the “N” (Neutral) position.
If the gearshift lever is moved to a posi-
tion other than the “N” (Neutral) position,
the
indicator display blinks and the
buzzer sounds.
If the gearshift lever is returned to the “N”
(Neutral) position, the
indicator
display stops blinking and the buzzer
stops sounding. The engine will not re-
start if the gearshift lever is in a position
other than the “N” (Neutral) position.
NOTE
l
In the following cases, the indicator
display will blink to inform the driver and
the engine will not stop automatically.
• Driver’s seat belt is not fastened
• Driver’s door is open
• Bonnet is open
l
In the following cases, the indicator
display will turn off and the engine will not
stop automatically even if the vehicle is
stopped.
• After the engine is started, the vehicle
speed never exceeded approximately
5 km/h (3 mph).
• After the engine is started, approximately
30 seconds or more have not elapsed.
NOTE
• After the engine restarts automatically
and the vehicle stops again within 10 sec-
onds.
• Diesel particulate filter (DPF) is burning
away trapped particulate matter (PM).
• Engine coolant temperature is low.
• Ambient temperature is low.
• When using the heater, the vehicle interior
temperature is not warm enough.
• Air conditioning is operating and passen-
ger compartment has not sufficiently
cooled.
• Demister switch is pressed.
Refer to “Demisting of the windscreen
and door windows” on page 7-06.
• When the air conditioning is operated in
automatic mode where the temperature
control is set to the max. hot or the max.
cool.
• Electric power consumption is high, such
as when the rear window demister or oth-
er electrical components are operating or
the blower speed is set to a high setting.
• Battery volume, voltage or battery per-
formance is low.
• “Check engine warning lamp” is illumina-
ted or the
indicator display is blink-
ing.
• The selector lever is another position than
in the “D” (DRIVE) position (A/T or
CVT).
• ASC operation indicator and ASC OFF
indicator is turned on (A/T or CVT).
NOTE
• ABS warning lamp is turned on.
• A/T or CVT warning lamp will turn on/
warning display will display.
l In the following cases, the engine will not
stop automatically even if the
indica-
tor display turned on.
•
The accelerator pedal is depressed.
• The brake booster vacuum pressure is
low.
• The steering wheel is operated.
• The brake pedal is not sufficiently de-
pressed (A/T or CVT).
• The vehicle is being parked on a steep hill
(A/T or CVT).
• The parking brake operates (A/T or
CVT).
l On vehicles equipped with M/T, do not rest
your foot on the clutch pedal while driving
because this will cause detection of clutch
pedal switch malfunction and blinking of
AS&G OFF display, and AS&G system will
not operate.
l If the AS&G system operates while the air
conditioning is operating, both the engine
and the air conditioning compressor will
stop. Therefore, only the blower will oper-
ate, the windows may start to fog up. If this
occurs, press the demister switch to restart
the engine.
Refer to “Demisting of the windscreen and
door windows” on page 7-06.
Auto Stop & Go (AS&G) system*
6-32
OGKE20E1
Starting and driving
6