PHOTOS
OPERATING PROCEDURE
59
8. Leg cover
Remove the leg cover by sliding back and forward.
After adjusting the casters, install the leg cover by sliding back
and forward.
Before installing the leg cover, be sure to adjust the casters.
7. Rotational heater board
(1) Remove 4 fixing screws to remove the rotational heater board.
(See photo 40)
(2) Remove a screw on the wiring cover and disconnect the con-
nector in the cover. (See photo 40)
Caution on assembly
When raising the rotational heater board, replace the rotational
heater board as it was. If the refrigerator door is closed with
the board raised, the rotational heater board may hit against
the left door of refrigerator and be damaged.
Though the anti-condensation heater may make rotational
heater board hot, it does not affect food inside.
Refer to the right figure when installing the rotational heater
board. (See figure 6)
Loosen the fixing screw and adjust a vertical (upper and
lower) motion.
After assembling, make sure that the rotational heater board
fits the guide properly and works properly.
Figure 6
Guide
(4)mm
3 2mm
(715)
Rotational heater
board
Left door of
refrigerator
compartment
Photo 40
Photo 41
Screws
Rotational
heater board
Wiring cover
Screws
Screw
(Wiring cover)
Leg cover
Catch
Catch
Casters
Removing
Installing