OPERATING PROCEDURE
PHOTOS
54
(11)
Remove the 4-pin connector that is stowed in the contoured
section of main refrigerator housing.
Detach the brazed section of piping. Remove the catch pro-
truding from the contoured section of main refrigerator hous-
ing to remove the evaporator. (See photo 23, figure 1, 2)
Installation:
Attach the evaporator to the catch protruding from the main
refrigerator housing. (See figure 1, 2)
Check both the entry side (black tube) and the exit side (gray
tube) of the evaporator. Braze the entry side to the pipe with
black marking, leading from the main refrigerator housing;
and the exit side to the other pipe.
Figure 2
Connect the connector leading from the evaporator to the con-
nector on the contouring section of main refrigerator housing.
Stow the lead wires in the contouring section and cover it with
seal tape.
Evaporator
outlet pipe
Gray tube
Unit outlet pipe
No marking
Exit side
Evaporator
inlet pipe
Black tube
Unit inlet pipe
With marking
Entry side
30
Evaporator
Defrost heater 1
DEF thermistor
Defrost
heater 2
Brazed section
Catch to fix the evaporator
Catch to fix the defrost heater
Pull the evaporator up in the direction of arrow
A to detach it from the catch.Slide the defrost
heater out in the direction of arrow B.
Catch to
fix the
evaporator
Catch to fix the defrost heater
Evaporator
Heater roof
Evaporator
Figure 1
Figure 2
Photo 23
The refrigerant flows in the muffler from top to bot-
tom. The pipe from the evaporator exit leads to the
top of the muffler. The pipe from the muffler (gray
tube) leads to the no-marking unit outlet pipe.
Evaporator
