OPERATING PROCEDURE
PHOTOS
55
Lead wire
Defrost heater 1
Tab
Lead wire
Defrost heater 1
Seal tape
Defrost heater 1
Defrost heater
connector
Bullet terminal
Tab
Seal tape
Defrost heater 1
Heater roof
Remove the defrost heater from the clips on the both ends
of the heater roof.
The arrow C indicates the front side of the refrigerator.
Drip tray
Aluminum tape (4 sides)
Defrost heater 2
Defrost heater 2
Put 4 pieces of seal tape on the
positions indicated in the picture
above.
Defrost heater
connector
Defrost heater 2
Stow the bullet terminal (right) and defrost
heater connector (left) in the contouring
section. Cover it with seal tape.
Figure 3
Figure 4
Photo 24
Photo 25
Photo 26
Photo 27
(12) Detach the defrost heater from the catch on the main refrig-
erator housing. Slide the defrost heater out towards you.
Remove the defrost heater from the heater roof. (See figure 3)
Remove the aluminum tape, then the drip tray. (See figure 4)
Installation:
Attach the drip tray so that it closely fits into the right place of
the main refrigerator housing. (See figure 4)
Loosen the lead wires to prevent water from entering the
glass tube. Make sure the orientation of the defrost heater is
correct. (See figure 3)
Attach the defrost heater to the catch. Use the respective tabs
to secure the 2 lead wires on the left and right side of main
refrigerator housing. (See photo 24, 25)
Fix the lead wires to the main refrigerator housing with seal
tape. (See photo 26)
Firmly connect the bullet terminal (right) with the defrost
heater connector (left). Stow the lead wires in the contouring
section of main refrigerator housing. Cover that section with
seal tape. (Use the seal tape provided with the evaporator.)
(See photo 27)
Defrost heater
Drip tray