Mitsubishi Electric Melsec WS Series, Руководство пользователя

Страница: 126 / 142

MELSEC-WS
Procedures before operation
123
The following table lists data to be sent at reading.
Device
Configuration
value (hex)
Byte
swapping *1
Description
D700 000A
H
Not required Send data length (10 bytes)
D701 00F1
H
Required
Command
D702 0001
H
Read data specification (Input data set
1 reading)
D703 0001
H
Read data specification (Input data set
2 reading)
D704 0001
H
Read data specification (Input data set
3 reading)
D705 0000
H
Read data specification (Input data set
4 not reading)
*1 Since the QJ71E71-100 treats application data in Little Endian format, the byte-order needs to be
swapped.
Since the QSCPU does not support the SWAP instruction, the upper and lower bytes are swapped in
the following way.
1) Store the swap-target data into the areas (M1000 to M1015).
2) Move the lower-byte data in the areas (M1000 to M1007) to the other areas (M1016 to M1023).
3) Return the data in the areas (M1008 to M1023) to the original device.
(3) Monitoring data with a programming tool
The read input data sets can be monitored using the device monitor function of a
programming tool. For the execution results of the program, refer to Section
8.2.2 (3).
Table 45:
Data to be sent at
reading