Mitel SX-200 ICP - 1.0 5020, Руководство техника

Страница: 187 / 360

179
Routine Maintenance
Installing FRUs
Only persons who have successfully completed a Mitel Installation and
Maintenance training course for the SX-200 ICP should perform removal
and replacement procedures.
Precautions
Observe the following precautions when working on the system,
particularly when handling PCB cards or using test equipment to measure
voltages.
• When installing or replacing PCB cards turn power off, but maintain
the ground connections to the equipment. Power must be OFF when
inserting or removing cards. These cards are identified with
appropriate warnings on their faceplates.
• Always wear an antistatic wrist strap when handling printed circuit
cards. Handle PCB cards only by the edges and avoid contact with any
exposed electrical connections. When removing a new card from its
package, touch the package to the cabinet frame first to release any
static voltage buildup, prior to removing the card and inserting it into
the equipment.
• Conductive packages (antistatic packaging) should be grounded prior
to opening them to remove the contents, and similarly grounded prior
to placing a card in the package. Place suspected faulty cards in
conductive packages to prevent further possible damage to the cards.
Cards that are not correctly packed in antistatic packaging when
returned will not be covered by any warranty.
Powering the Controller Up or Down
The controller does not have a power switch. To power it up or down,
connect or disconnect the power cord from controller or the wall outlet. Or
switch power to the outlet on or off.
WARNING: INSTRUCTIONS MUST BE FOLLOWED EXPLICITLY
WHEN THEY INVOLVE WORK WITH AND CHANGES TO THE
PRIMARY POWER SUPPLY OF THE UNIT.
Use proper fitting Phillips screwdrivers (#1 or #2) to prevent
damaging components and fasteners.