Instruction Manual MIT-SCAN-T3
Version 02/2021
Page 5
Safety instructions
•
Recharge the battery when the corresponding icon appears on the
display. Do not leave the device unattended while charging.
•
Power off the device before exchanging the battery.
•
Do not use the device if the housing is damaged.
•
Observe the operating conditions (e.g. operating temperature)
specified under “Technical data” to prevent damage to the device.
•
Though the housing seals have been tested extensively, it is
possible that water may enter the device during heavy rainfall. If
this happens, stop operating the device and ensure it is completely
dry before using it again.
•
When taking measurements on hot asphalt make sure only the
sensor unit contacts the asphalt. Electronics as well as mechanical
parts of the control unit are designed for the from −10 °C to
+50 °C only.
•
Observe local safety regulations when performing measurements.
•
Mechanical loads, such as permanent vibrations or impacts on a
hard surface may cause damages and malfunctions such as
measurement errors. In this case, the device has to be checked by
the manufacturer and, if necessary, has to be recalibrated.
