Installation and Programming Manual
Mircom Technologies Inc
All Rights Reserved
LT-1034 Rev.1
Page 52 of 54
NMC is dependent on the fire alarm system control panel to function properly and to signal the NMC to
initiate an alarm sequence for the ISD-1000 to signal the occupants.
-Alarm Notification Appliances
The In-suite Signaling Devices (ISD-1000’s) are designed to be a supplemental signaling device to
augment and NOT replace the existing signaling capabilities of the primary Fire Alarm System in the
building. Even though the ISDs will be verified, at the on-set, for maximum signaling performance, they
are portable and can be installed in the suite living areas during daytime hours. It is up to the occupant to
ensure that the ISD is plugged into a wall outlet that gives the highest decibel level rating to that
individual. The ISD devices are supervised for placement in the Network and have a programmable delay
feature. This delay feature permits relocation without causing a trouble condition on the NMC control unit.
However, this supervisory feature may fail and communications will be lost. It is up to the Occupant to
insure that the ISD unit is plugged into the AC wall outlet and has not been unplugged and that the AC
circuit breaker that the ISD unit is plugged into is ‘ON’ and has not been flipped to the ‘OFF’ position.
-Insufficient Time
There may be circumstances when the system will operate as intended, yet the occupants will not be
protected from the emergency due to their inability to respond to the warnings in a timely manner. If the
system is monitored, the response may not occur in time enough to protect the occupants or their
belongings.
-Component Failure
Although every effort has been made to make this signaling system as reliable as possible, the system
may fail to function as intended due to the failure of a component.
-Inadequate Testing
Most problems that would prevent an alarm system from operating as intended can be discovered by
regular testing (monthly and annually) and routine maintenance. The complete system should be tested
as required by national standards and the Local Authority Having Jurisdiction and immediately after a fire,
storm, earthquake, accident, or any kind of construction activity inside or outside the premises. The
testing should include all sensing devices, keypads, consoles, alarm indicating devices and any other
operational devices that are part of the total system.
-Security and Insurance
Regardless of its capabilities, an alarm system is NOT a substitute for property or life insurance. An alarm
system also is NOT a substitute for property owners, renters or other occupants to act prudently to
prevent or minimize the harmful Effects of an emergency situation.
IMPORTANT NOTE: END-USERS OF THE SYSTEM MUST TAKE CARE TO ENSURE THAT THE
SYSTEM, BATTERIES, TELEPHONE LINES, ETC. ARE TESTED AND EXAMINED ON A REGULAR BASIS
TO ENSURE THE MINIMIZATION OF SYSTEM FAILURE.
LIMITED WARRANTY AND RETURNED GOODS AUTHORIZATIONS
Mircom Technologies Ltd. warrants the original purchaser for a period of two (2) years from the date of purchase,
that the product shall be free of defects in materials and workmanship under normal use. During the warranty
Содержание Fire-Link ISD-1000 Series
Страница 2: ......
