Installation and Programming Manual
Mircom Technologies Inc
All Rights Reserved
LT-1034 Rev.1
Page 9 of 54
2.0 NMC-100 INSTALLATION
General Precautions:
WARNING: Several different sources of power can be connected to the NMC unit. Disconnect all
sources of power before servicing. This unit and associated apparatus may be damaged by removing
and/or installing circuit boards, modules or interconnecting cables or wiring while this unit is energized.
Do not attempt to install or service or operate this unit until this manual is read and understood.
This unit should be installed and serviced by qualified personnel ONLY.
DO NOT:
•
Install the unit outdoors.
•
Install the unit where it will be subjected to extreme heat, 120F (48C).
•
Install the unit where it will be subjected to extreme cold, 32F (0C).
•
Install the unit where it will be subjected to moisture.
•
Install the unit in a hazardous location.
•
Install the unit near flammable, explosive or corrosive chemicals or materials.
•
Install the unit where it will be subjected to excessive dust or dirt.
•
Install the unit near flame or sources of heat or ignition.
•
Install the unit on or near sources of excessive vibration.
•
Install the unit inside an electrical distribution or control panel.
•
Install the unit near sources of electro magnetic interference (EMI) such as lighting ballasts or
motor control centers.
•
Install on the LINE side of any buck, boost or distribution transformer.
•
Install on any service exceeding 250 Volts RMS.
•
Install the unit near obstructions or where it could be subject to obstruction or prevent
operation, servicing or maintenance.
•
Install the unit where it could be subjected to physical damage.
•
Install the unit on any surface other than a flat surface.
•
Allow wiring to be exposed or installed in a manner in which the wiring could become exposed.
•
Attempt to modify the unit in any way.
•
Install, operate or service the unit without reading and understanding this manual.
Содержание Fire-Link ISD-1000 Series
Страница 2: ......
