9.1 Drive Control Unit
ATECH / ZAPI
•
9 1 Automatic Monitoring of Components
9.1 Automatic Monitoring of Components
•The micro-processor executes evaluation of basic controller functions.
•This evaluation concerns the following 4 states:
•Check upon switching on by key switch:
•Watchdog, current sensor, power MOS FETs, contactor drive (contactor driver), direction
switch, potentiometer connections, EEPROM
•Check during standstill:
•Watchdog, current, power MOS FETs, contactor drive (contactor driver), potentiometer
ti
connections
•Check during ride:
•Watchdog, current, power MOS FETs, contactor drive (contactor driver), potentiometer
connections, closing and opening of contactors
P
t
it i
•Permanent monitoring:
•Temperature, battery voltage
•Eventual error messages are displayed via flashing LED at connector B (paragraph 2).
Error type can be differentiated by number of flashes.
53
Содержание ERIDE 30
