8
Figure 5. Voltage Follower
Connections With Signal
Greater than 3.5VDC
3
5
4
+ (POS)
- (NEG)
1
2
3
4
5
TERMINAL
BOARD
NEG
(-)
POS
(+)
SIGNAL INPUT
SPEED
ADJUST
POT
10K
Ω
Voltage follower
Instead of using a speed adjust potentiometer, the drive may be
wired to follow an analog input voltage signal (0 – 3.5 VDC) that
is isolated from earth ground (Figure 4). Connect the signal input
(+) to terminal 4. Connect the signal common (–) to terminal 3.
Make no connection to 5.
If the maximum signal is greater than 3.5V, use the speed adjust
pot as a trimmer. See Figure 5 for connections. With the signal at
maximum, use the speed adjust pot to set the motor to the desired
maximum speed. It is advised that the speed adjust pot be
secured to preclude inadvertent tampering with this important
setting.
Installation
Figure 4. Voltage Follower
Connections
SIGNAL INPUT
POS ( + )
NEG ( - )
TERMINAL
BOARD
SPEED
ADJUST
POT
10 K OHM
NEG
( - )
1
2
3
4
5
3
4
5
POS
( + )
All manuals and user guides at all-guides.com