MIMAKI DS-1600, Руководство по эксплуатации

Страница: 77 / 172

- 2.11 -
Checking nozzle in ink firing condition
Executing the test draw [TEST DRAW]
In prior to the actual printing or after the execution of the cleaning function, a test pattern is plotted
to check whether the finished test pattern has blurred and missing lines on test pattern)
• If the finished test pattern shows any sign of abnormal conditions, carry out
the cleaning function. (See page 2.12)
STEPS:
1. Make sure the mode is LOCAL mode.
Press the [REMOTE] key and put the device back into the LO-
CAL mode.
2. Press the [TEST] key.
3. Press the [ENTER] key.
After printing the test patten the device enters the LOCAL mode.
• This function can be executed even during
host data printing. In this case, however, some
host data will be missing. The amount of miss-
ing data depends on the medium width, num-
ber of paths, resolution, and data transfer rate
of the host.
4. When test printing is performed during host data
printing, press the [REMOTE] key.
The plotter enters the REMOTE mode
.
Checking the test patterns
The plotter plots a test pattern for each of the ink head. Check the test pattern to determine
whether or not the ink head need cleaning.
Out put direction
R-row inkhead
F-row inkhead
Test pattern
Line are not drawn at uniform intervals.
(BLURRED)
Horizontal lines are not at all drawn.
(Missing lines)
< < L O C A L > >
w i d t h : 1 2 7 2m m
T E S T D R A W
< E N T >
* * T E S T
D RA W * *
< < L O C A L > >
w i d t h : 1 2 7 2m m
< R E M O T E >
T Y P E 1
0 . 0 m