MIMAKI DS-1600, Руководство по эксплуатации

Страница: 118 / 172

- 4.8 -
Moving the carriage to clean the station interior [CARRIAGEout]
This function moves the carriage for maintenance of the ink station.
The interior of the station needs maintenance when a blurred test pattern is not corrected
even after the cleaning function (page 2.12) is executed or when a consumable part is to be
replaced. Frequently wipe the capping station clean to eliminate dust and paper chips. Wip-
ing with a fluffy wiper only rubs dust over the capping station. Replace the fluffy wiper imme-
diately with a new one.
• Do not move the carriage out of the capping station by hand.
Use the appropriate operation key to move the carriage.
• Before performing [STATION], be sure to move down the clamp lever on the
front side of this plotter.
STEPS:
1. Move down the clamp lever on the front face of
the plotter.
2. Select [
STATION
] from [MAINTENANCE].
(See page 4.3)
3. Press the [ENTER] key.
4. Press the [ENTER] key.
The carriage is moved from the maintenance station.
5. Open the maintenance cover, then perform the
following maintenance works for the station in-
terior.
The following maintenance should be executed:
1. Cleaning the ink cap (See page 4.9)
Clean the surfaces around the ink caps in the station.
2. Cleaning or replacing the wiper (See page 4.11-13)
Clean or replace the wiper.
• When the message "Replace Wiper" is dis-
played on the LCD, replace the wiper.
Remove these screws
M A I N T E N A N C E
S T A T I O N < e n t >
S T A T I O N M A I N T
M A I N T : CA R R I AGE ou t
C AR R I A GE o u t
C OM P L E T E D
: en t