- 1.35 -
Setting the fabric to the plotter
The fabric that can be used are roll and leaf fabric.
Leaf fabric is handled in the same manner as roll fabric for printing.
When using leaf paper for setup list printing, for example, be careful about the setting position.
This operation should be performed by 2 or more person bcause the roll is heavy in weight.
Setting a roll fablic (In case of DS-1600/1800AMF model)
STEPS:
1.
Open the roll shaft cover of the taking-up unit
and take the roll shaft out.
2.
Remove the roll holder attached to the roll shaft.
Remove one of the two roll holder.
• When the fabric core support (option) is at-
tached to the roll shaft, go to step 3.
When the fabric core support is not attached
to the roll shaft, go to step 7.
3.
Loosen the screws fixed to the fabric core sup-
port on the roll shaft using supplied hexagonal
wrench and then slide the fabric core support to
the center of the using roll width.
Содержание DS-1600
