MIMAKI DS-1600, Руководство по эксплуатации

Страница: 155 / 172

- 5.9 -
An error occurs in communica-
tion between I/F board and main
board.
I/F board has not been installed.
HOST I/F Timeout error has
arisen during communication
between the host computer and
interface board.
Initial operation failure of the
I/F board and control board.
Improper operation has been
conducted on the operation
panel.
Settings for functions have been
tried to be changed though
there remains received data
that has not yet been printed.
The Xmotor has been overload.
The Ymotor has been overload.
Overcurrent error on the Xmotor
has been detected.
Overcurrent error on the Ymotor
has been detected.
Incorrect height of the capping
station has been detected.
The wiping device is defective.
Error message Cause Corrective measure
Turn off the power to the plotter
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Install the I/F board.
Check to be sure that the cable
is securely connected to the host
computer and interface board.
Also, check to ascertain that no
error has arisen on the host com-
puter side.
Turn off the power to the plotter
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Perform a proper operation.
Print all pieces of received data
or execute the data clear function.
Then, change the settings.
Turn off the power to the plotter
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
E R R O R 2 0
I / F B O A R D
E R R O R 2 1
I / F N O N E
E R R O R 2 3
H O S T I / F
E R R O R 2 4
I / F I N I T I A L
E R R O R 3 0
OP E R A T I O N
E R R O R 3 4
DA T A R E M A I N
E R R O R 4 0
M O T O R X
E R R O R 4 1
M O T O R Y
E R R O R 4 2
X OV E R C U R R EN T
E R R O R 4 3
Y OV E R C U R R EN T
E R R O R 4 5
C A P P I N G
E R R O R 4 6
W I P I N G