MIMAKI CJV30-100BS, Руководство по эксплуатации

Страница: 248 / 296

7-8
Message Cause Solution
There is a problem with the installed ink
cartridges. Check the warning details in the guidance
function. (
P.7-5)
There are the following problems with the
cleaning solution:
The cleaning solution is not set.
Something other than the cleaning solution is set.
The cleaning solution is ended.
Replace the cleaning solution.
As the connection unit is not connected to the
print head, regular operations cannot be
executed. Start the origin setting in the print mode, and
switch the connection unit, or execure the
appropriate regular operations manually.
The waste ink tank is nearly full.
Replace the waste ink tank, and then execute
[MAINTENANCE]-[Ink Tank Replace].
(
P.6-41)
The cleaning liquid cartridge is empty.
Replace the cleaning solution cartridge with a
new one.
The cleaning liquid cartridge has not been
installed.
Install the cleaning solution cartridge.
There is trouble with the cleaning liquid
cartridge.
Install the cleaning solution cartridge.
Cleaning solution has not been supplied.
Supply the cleaning solution.
Execute [MAINTENANCE]-
[HD.MAINTENANCE]-[FILL UP INK].
(
P.6-21)
** OFFSCALE **
The cutting data exceeds the effective cutting
area.
Or the machine has stopped after cutting the
medium up to its end normally. Use a larger medium, decrease the amount of
data, or execute the divided cutting function.
This warning may occur depending on the set
value of the P/C origin offset (
P.4-32).
** END COPY **
The plotter has terminated copying after
completion of one sheet copying, since the data
received contains the origin updating command.
The plural sheets cutting function is disabled.
To perform plural sheets cutting, change the
setting back to enable the function on the host
computer.
** DIVISION ** 5s
The machine has finished the cutting
corresponding to a division of the data that
exceeds the medium width, using the division
cut function, and is now waiting for the receipt of
the next data. If the machine does not receive any data from
the host computer within ten seconds, it will
recognize that the data has ended.
Then, the machine will perform the frame cutting
and mark cutting and enter LOCAL.
** END DIVISION **
This message appears in any of the following
cases:
The medium width is 1 cm or less.
The sample cutting data exceeds the medium
width.
The two-point axis alignment is set to ON.
Register marks have already been detected.
Division cut is disabled.
< L O C A L . 1 > ! C A R [ # 0 1 ]
* R E MO T E . 1 * ! C A R [ # 0 1 ]
< L O C A L . 1 > ! WS H [ # 0 1 ]
* R E MO T E . 1 * ! WS H [ # 0 1 ]
< L O C A L . 1 > ! R T N [ # 0 1 ]
* R E MO T E . 1 * ! R T N [ # 0 1 ]
< L O C A L . 1 > ! T N K [ # 0 1 ]
* R E MO T E . 1 * ! T N K [ # 0 1 ]
< L O C A L . 1 > [ # 0 1 ]
! WA S T E T A N K
< L O C A L . 1 > [ # 0 1 ]
! Wa s h L i q u i d E N D
< L O C A L . 1 > [ # 0 1 ]
! w a s h L i q u i d C a r t . N ON
< L O C A L . 1 > [ # 0 1 ]
! WR O N G WA S H C A R T .
* * Wa s h i n g l i q u i d * *