MIMAKI CFL-605RT, Руководство по эксплуатации

Страница: 59 / 170

2-19
1
2
Basic Operation
s
5
5
6
Making a Test Cut
Crease Roller
Swivel Blade
Check Point Cause Remedy See page
Point A contact points do
not match
Blade is mounted eccentrically
Conduct Adjust Eccentricity in tool
adjustments.
P.6-4
Lines displaced at Point A
Abnormal angle

of crease
roller
Conduct Adjust

in tool
adjustments.
P.6-9
Crease is weak Press value low
Increase the “PRESSURE” in the
cutting conditions.
P.2-11
Crease lines torn along
flutes
of corrugate
cardboard.
Y PRESS value in the cutting
conditions is too high.
Align the corrugated cardboard
flutes in the Y-axis direction.
Decrease the “Y PRESS” in the
cutting conditions.
P.2-11
Check Point Cause Remedy See page
Broken lines
Swivel cutter incorrectly
mounted.
Fully tighten the holder screw.
P.1-13
Speed is too slow.
Increase the “SPEED” in the cutting
conditions.
P.2-12
Press value low
Increase the “PRESSURE” in the
cutting conditions.
P.2-11
Corners rounded off
The blade does not protrude
enough. Increase the amount that the blade
protrudes.
P.2-14
Offset value is too small.
Increase the “OFFSET” in the
cutting conditions.
P.2-11