MIMAKI CFL-605RT, Руководство по эксплуатации

Страница: 159 / 170

6-15
1
1
1
1
Tr
oubleshooting
6
Troubleshooting
Tool lifts up the paper
Drawn lines are broken or smudged
No reciprocating movement
Is the paper (sheet) wrinkled or flexed? Flatten out the work. ( P.2-6)
Is pen up / down operation defective?
Turn off the power and move Unit A vertically.
Contact your Mimaki representative if Unit A does
not move up and down normally.
Isn't Z stroke too small?
Change the Z stroke value.
(
P.3-16)
Isn't pen up height too low?
Lift up the pen up height.
(
P.3-23)
Is the Unit A screw loose? Re-tighten the Unit A screw. ( P.2-14)
Is the drawing speed too high?
Decrease the “SPEED” in the cutting conditions.
(
P.2-12)
Is the drawing pressure too low?
Increase the “PRESSURE” in the cutting
conditions. (
P.2-11)
Is the pen out of ink?
Replace the pen with a new one.
(
P.1-13)
Inadequate lubrication of the
reciprocating shaft? Apply a small amount of grease to the shaft.
(
P.5-3)
Is the oscillation movement turned off?
Set the “VIBRATION” cutting condition from 1 to 5.
(
P.2-11)
Contact your Mimaki representative if reciprocating
movement does not start.
Isn't the protection door open? Firmly close the protection door.
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes