MIMAKI CFL-605RT, Руководство по эксплуатации

Страница: 51 / 170

2-11
1
2
Basic Operation
s
5
5
6
Selecting Tools
Set Items
The cutting condition set items differ according to the tool.
Set Item
Tool Type
Set value Set value
A B
Swivel
cutter
Pen
R
eciproca
ting cutte
r
Crease
rol
ler

Cutt
e
r
CUT SPEED
○ ○ ○ ○ ○
0.2~30 (cm/s)
Speed of tool movement in the X or Y direction.
Changes according to the type of tool and workpiece
and the data size.
PRESSURE
○
30 ~ 150
(100 or less: per 5g, 100 ~
150: per 10g)
Pressure when cutting the workpiece with a press tool.
○
30 ~ 1000
(100 or less: per 5g, 100 ~
400: per 10g, 400 ~: per 50g)
○
*
○ ○
500 ~ 1500
(500 ~: per 100g)
* Fixed 1500g in setting
VIBRATION
OFFSET
○
0.0 0~ 2.50 (step 0.05mm)
This is the offset value for the tip of the swivel blade
cutter. Change the setting according to the workpiece
thickness and wear of the cutter blade.
ACCELERATI
ON
○ ○ ○ ○
0.1 ~ 0.7 (step 0.1G)
Maximum tool acceleration. Changes according to the
type of tool and workpiece and the data size.
VIBRATION
○
OFF, 1000 ~ 3000
Vibration speed (rpm) of the reciprocating tool.
Set OFF when using cutter holder 2N

.
RING DIST.
○ ○ ○
0.0 0~ 2.50 (step 0.05mm)
Sets the rounding radius (R) and adds a line segment
between segments for a consecutive series of line segments.
This reduces the degree of damage to the workpiece by the
tool.
START CORR.
○ ○
0.0 0~ 2.50 (step 0.05mm)
Offset for cutting start position when the tool descends.
When cutting a thick workpiece, setting this offset to a
large value cuts from the front of the workpiece to simplify
separation.Adjust this setting while checking the finish.
END CORR.
○ ○
0.0 0~ 2.50 (step 0.05mm)
Offset for cutting end position when the tool ascends.
When cutting a thick workpiece, setting this offset to a
large value makes an extra cut from the end position that
simplifies.Adjust this setting while checking the finish.
UP ANGLE
○ ○ ○
0 ~ 180 (step 1 °)
Sets the minimum angle to raise the cutter and change the
direction, when changing the cutting (crease) direction. This
reduces the degree of damage to the workpiece by the tool.
PRESS CORR.
○ ○ ○
0 ~ 500 (step 100g)
Corrects the tool downwards pressure when cutting
(crease cutting) a thick workpiece. Applying the PRESS
COR value to the previously set press value ensures
Y PRESS
○
-1500 ~ +1500 (step 100g)
Corrects the press value in the Y-axis direction to allow crease
cutting with a different pressure to the X-axis direction. When
crease cutting corrugated cardboard, position the corrugated
cardboard with the flutes in the Y direction to cut with a lighter
pressure than in the X direction.