Page 26
Operating Manual Sintering Oven HTS-2/M/Zirkon-120
Version 5.0 - 10/2018
Initial commissioning
Programming the heating levels
The control provides the option of setting the
sintering oven
heat-up in 1-4
heating levels as a heating program. Heating and cooling is possible within
a heating program.
If no setting is made within one minute during the programming, the cursor
will disappear and an acoustic signal sounds.
1.
Press the
S1
button.
Â
The cursor for entry flashes in the
/min
field.
2.
Enter the heating rate using the numerals 0-9.
The minimum heating speed is 1°C/min (2°F/min),
the maximum heating speed is 99°C/min (178°F/min).
Â
If the entry is below a two-digit value, the cursor must be moved over
the relevant level button to the next input field.
Â
After entering the heating rate, the cursor skips to the next input field.
3.
Use the numerals 0-9 to enter the four-digit holding temperature that
the oven is to heat up to in the heating level
S1
.
Notice
The maximum programmable temperature of the
sintering oven
is
1650°C.
If a higher temperature is entered, the display skips back to the previous
value.
Â
After entering the temperature value, the cursor skips to the next
input field.
Â
If the entry is below a four-digit value, the cursor must be moved over
the relevant level button to the next input field.
S1
