Microtronics myDatalogEASYplus, Руководство пользователя

Страница: 35 / 139

Chapter 5 Functional principle
5.1.10 Scale module (outputs)
This module rescales the setpoint (e.g. mm) into the desired physical size (e.g. frequency) for the
output.
The following table specifies the relevant parameters for the module:
Configuration section Mode Parameter Explanation
Output channels Off --- ---
Ext warmup
time
1)
Digital Basis ->
Invert Inverts the level issued on the device
Freq Basis ->
Factor The setpoint multiplied by the factor
equals the frequency in Hertz. The result
of the multiplication must not exceed
500 Hz.
PWM Basis -> 0% Start of the output range in the
measurement unit
Basis ->
100% End of the output range in the
measurement unit
Pulse Basis ->
Factor The setpoint multiplied by the factor
equals the pulse/min. The result of the
multiplication must not exceed
30,000 pulses/min.
Config ->
Duration Duration of an output pulse [ms]
1)
In "Ext warmup time" mode, the output is actuated by the device itself to activate the sensor supply for the measurement
(see "Output channels" on page 88).
5.2 Functionality of the internal data memory
Structure Circular buffer
Total size 25.588 measurement
cycles
Number of sectors 4
Sector size 6397 measurement
cycles
Rev. 06 35