Microscan Quadrus EZ, Руководство пользователя, Страница: 298 / 366

15-4
Quadrus EZ Reader User’s Manual
Assigning a Network Address
This procedure will configure the reader to work with the TCP/IP configuration of the host
computer.
Note: This is only a temporary solution since the preferred method is to receive IP, subnet,
and gateway (if necessary) from your IS department.
If an IP address has been assigned to the reader by the IS department (the most appropriate
method), skip steps 1-3 below.
1. Determine the host computer's IP address on the host's network:
Go to the Windows Start menu, select Run , type command and press Enter .
a) On Win2K computers, at the command prompt, type ipconfig .
b) On Win98 computers type winipcfg and select the Ethernet Interface in the
drop-down box.
2. To the IP Address of the host computer add '1' to the last decimal value. This will be
the IP address that you will assign to the reader.
For example, if the host computer's IP is 123.234.1.25, the reader's IP will be
123.234.1.26.
3. To verify that the new IP address is available, go back to the command prompt and
type in the command: ping [reader IP address] . For example: ping 123.234.1.26.
If the ping program responds with “Request timed out” message, then the IP
address can probably be used temporarily. If you get a “Reply” message, then that
address has already been assigned to another device and you need to contact your
IS department for an available IP address.
4. Do Receive Reader Settings .
5. From the ESP Communications menu, enter your reader's new IP address, for
example, 123.234.1.26, and save this to the reader.
The reader is now configured with an
IP address that will allow communica-
tion with the host computer. In the ESP
Communications menu, you should
see the following:
6. Go to Step 3, Communicating in
Ethernet.