Microscan Quadrus EZ, Руководство пользователя, Страница: 23 / 366

Quadrus EZ Reader User’s Manual
1-11
Quick Start
Step 9 — Perform Readability Test
This test will let you know the percent of good reads per captures achieved by the reader.
Testing by EZ Button
1. To start the read rate
test, hold down the EZ
setup button about 3
seconds until you hear
three short beeps and
see the alternating IP
and finder pattern LEDs.
While the symbol is
being decoded, the read
rate LEDs will indicate
the corresponding read
rate percentage on the
side of the unit.
2. To end the read rate test,
press the EZ button and
quickly release.
Testing by ESP
1. Click the Test button to
start the read rate test
and
Stop to end it.
If your symbol has been
successfully decoded, its
data and related features
will be presented under
“Symbol Information.”
Also, while the symbol is
being decoded, the read rate LEDs will indicate the corresponding read rate percentage
on the side of the unit as shown above.
2. To end the test, click the Stop button.
Testing by Serial Command
You can also start a test with the <C> or <Cp> command and end it with the <J> command.
20%, 40%, 60%, 80%, 100% -
these LEDs are only active while
the reader is in a read rate test
and represent the percentage of
good reads per images captured.
Good Read Percentage