Microscan Quadrus EZ, Руководство пользователя, Страница: 220 / 366

9-12
Quadrus EZ Reader User’s Manual
Dynamic Setup
Dynamic Setup
You can visually determine where moving symbols will appear in the FOV during a read
cycle by adjusting the delay time before capture.
Note: If not already in Edge and Rapid modes, the reader will automatically change to
those settings when you open the Dynamic window.
1. First set the Captures # .
2. Next set the Number of Captures and Number of Symbols that will be read during
the read cycle.
3. Set Delay time.
If Number of Captures is set to 1 ,
Delay time will be the time between
the start of a read cycle and the first
capture. If set to any number other
than
1 , Delay time will be the time
between the capture set in Capture #
and the previous capture.
4. Start the moving application and trig-
ger the read cycle.
5. Adjust the Delay setting so that the
symbol appears near the center of the
window.
For example, if Number of Symbols is set
to
3 and Capture # is set to 1 , the Delay
time will represent the time before the cap-
ture. You can change the number by manu-
ally sliding the bar tab back and forth or by
typing in a number. Numbers in the Delay
box are rounded to the nearest value in ±32µS increments.
Note: If a read cycle trigger occurs before ESP has finished processing/receiving an
image from the previous read cycle, the trigger will be ignored. This is done to ensure that
ESP remains in sync with the reader.