Micronics 09-00232 Series, Руководство пользователя

Страница: 37 / 123

Installing the Optional Ethernet Module
The LPM30 supports an optional Ethernet module which can be ordered from
your dealer or directly from Micronics at (510) 651-2300.
Before installing the module, it is important to remove the knockout on the
back of the case so the 10 BASE-T connector may be connected to the
network (Figure 3-13).
Gently press against the knockout from the inside of the case until it is
perpendicular to the back of the case. Wiggle the knockout up and down until
it breaks free.
Figure 3-13 Removing the Ethernet Module Knockout
After you have removed the knockout, follow the steps below:
1. Refer to the antistatic precautions described on page 2-1.
2. Read the Ethernet module’s user manual and configure it for
installation.
3. Turn the computer system off and remove its cover.
4. Locate the Net connector illustrated in Figure 2-1.
5. Insert the module with the bottom edge level to the connectors (Figure
3-14). Never insert the module at an angle!
6. Carefully push the module straight down, making sure it is fully inserted.
7. Replace the computer cover.
3-15
Installing System Memory and Add-On Peripherals