MICRO-EPSILON capaNCDT 6500, Инструкция по эксплуатации

Страница: 24 / 68

capaNCDT 6500 Page 24
Operation
5. Operation
5.1 Starting Up
Pay attention to switching on the device, that you have plugged-in all boards in the des-
ignated positions.
Let warm up the measuring system for about 15 minutes before you run a measuring or
calibration. This avoids measuring inaccuracies.
5.2 Basic Settings
5.2.1 DT6530
After switching-on the power supply the three LED‘s show the existence of the internal
supply voltages. The controller is ready for use, if all three LED‘s flash.
Fig. 22 LED‘s for power supply
5.2.2 DD6530
The digital measuring values of all channels were shown on the display board DD6500.
The measuring values are scaled from 0 to 100 %. The display does not show the full
resolution of the measurement channel. Its 1/10000 display resolution for each channel
for monitoring purpose. For the maximum resolution of the displacement signal please
use the dialog or digital interface. The display settings, see Chap.
6.4.14 , enable
- a change between linearized or non-linearized values.
- a selection of channels for upgrading.
Fig. 23 Display and interface board Fig. 24 Change Ethernet/EtherCAT
A switch between Ethernet and EtherCAT, is possible via a hardware switch (image) or
via software.
If the switch is in position Ethernet, always the Ethernet interface is active independent
of the software setting. If the switch is in position ECAT/Auto, then the active interface
depends on the software setting. To change the interface it is necessary to restart the
controller.
NOTICE
Do not plug-in or unplug
any board during the
operation!
This leads to defaults of
the controller!