MICRO-EPSILON capaNCDT 6500, Инструкция по эксплуатации

Страница: 22 / 68

capaNCDT 6500 Page 22
Installation and Assembly
4.9 Pin Assignment
This module is used for signal display and output when measuring, calibrating or check-
ing the system. The output voltage can be tapped at the BNC connectors of the de-
modulator boards additionally.
Fig. 19 Measuring unit with controller, preamplifier, and sensors
37-pole Sub-D connector:
1 U-Out Channel 1 13 Trigger_In 25 AGND Channel 6
2 U-Out Channel 2 14 Sync_In-8M 26 AGND Channel 7
3 U-Out Channel 3 15 Sync_Out-8m 27 AGND Channel 8
4 U-Out Channel 4 16 Sync_In-31K 28 I-Out Channel 2
5 U-Out Channel 5 17 Sync_Out-31K 29 I-Out Channel 4
6 U-Out Channel 6 18 N.C. 30 I-Out Channel 6
7 U-Out Channel 7 19 N.C. 31 I-Out Channel 8
8 U-Out Channel 8 20 AGND Channel 1 32 GND_Trigger_I
9 I-Out Channel 1 21 AGND Channel 2 33 8M
10 I-Out Channel 3 22 AGND Channel 3 34 S 8M
11 I-Out Channel 5 23 AGND Channel 4 35 31K
12 I-Out Channel 7 24 AGND Channel 5 36 S 31K
37 n. c.
1 19
20 37
Fig. 20 View: Solder pin side, 37-pole male cable connector
In addition the following should be noted when assembling the user-side power supply
and trigger cable.
Use a screened cable.
Connect the screening mesh with the connector housing.
Use a separate screened cable for the trigger signal.
Maximum cable length amounts to 3 m.
Recommended conductor cross-section 0.14 mm
2.
The EMC regulations, see Chap. 1.3 , are only satisfied if these basic conditions have
been observed.