MGI M4000E series, Инструкция по эксплуатации

Страница: 155 / 215

144
PARAMETERS
4.2.39 Zero current detection (Pr. 152, Pr. 153)
Pr. 152 "zero current detection level"
Pr. 153 "zero current detection period"
When the inverter's output current falls to "0", torque will not be generated. This may
cause a gravity drop when the inverter is used in vertical lift application.
To prevent this, the output current "zero" signal can be output from the inverter to close
the mechanical brake when the output current has fallen to "zero".
•
If the output current remains lower than the Pr. 152 setting during inverter operation
for longer than the time set in Pr. 153, the zero current detection (Y13) signal is output
from the inverter's open collector output terminal.
(Use any of Pr. 190 to Pr. 192 to assign the terminal used for Y13 signal output.)
<Setting>
Refer to the following list and set the parameters:
Parameter
Number
Factory
Setting
Setting
Range
152 5.0% 0 to 200.0%
153 0.5 s 0.05 to 1 s
Parameter
Number
Description
152
Set the zero current detection level.
Set this parameter to define the percentage of the rated current at which the
zero current will be detected.
153
Set the zero current detection time.
Set a period of time from when the output current falls to or below the Pr. 152
setting to when the zero current detection signal (Y13) is output.
Note:1. If the current rises above the preset detection level but the timing condition
is not satisfied, the zero current detection signal is held on for about 100ms.
2. This function is also valid during execution of offline auto tuning.
3. When the terminal functions are changed using Pr. 190 to Pr. 192, the other
functions may be affected. Confirm the functions of the corresponding
terminals before making settings.
Pr. 190 to Pr. 192 (output
terminal function selection)
Related parameters
OFF ON
Start signal
Pr. 152 "zero current
detection level"
OFF
ON
Zero current
detection signal
output (Y13)
Pr.152
OFF ON
(Note)
Output current 0 [A]
100ms
Pr. 153 "detection time" Pr. 153 "detection time"
M4500E.book 144 ページ ２００５年２月２２日 火曜日 午後５時７分