MGI M4000E series, Инструкция по эксплуатации

Страница: 116 / 215

105
PARAMETERS
4
4.2.27 PWM carrier frequency (Pr. 72, Pr. 240)
Pr. 72 "PWM frequency selection"
Pr. 240 "Soft-PWM setting"
You can change the motor tone.
• By parameter setting, you can select Soft-PWM control which changes the motor
tone.
• Soft-PWM control changes motor noise from a metallic tone into an unoffending
complex tone.
<Setting>
• Refer to the following list and set the parameters:
Parameter
Number
Factory Setting Setting Range Remarks
72 1 0 to 15
0: 0.7kHz,
15: 14.5kHz
240 1 0, 1 1: Soft-PWM valid
Parameter
Number
Setting Description
72 0 to 15
PWM carrier frequency can be changed.
The setting displayed is in [kHz].
Note that 0 indicates 0.7kHz and 15 indicates 14.5kHz.
240
0 Soft-PWM invalid
1 When any of "0 to 5" is set in Pr. 72, Soft-PWM is made valid.
Note:1. Note that when the inverter is run at the ambient temperature above 40°C
(104°F) with a 2kHz or higher value set in Pr. 72, the rated output current of
the inverter must be reduced. (Refer to page 190 (depending upon the
inverter).)
2. An increased PWM frequency will decrease the motor sound but increase
noise and leakage currents. Therefore, perform the reduction techniques
(Refer to pages 35 to 39).
M4500E.book 105 ページ ２００５年２月２２日 火曜日 午後５時７分