FP4, FP4W
14
5 ELECTRICAL INSTALLATION
!
Prior the commencement of any connection works, read carefully the
information concerning safety described in section
SAFETY INFORMATION
.
Power supply and all signal wires are connected to plug-in screw terminals, situated at
the rear panel of the device (FP4) or spring terminals at the bottom of the device (FP4W).
Maximum wires cross-section area is 1.5 mm
2
. Both wire and cord cables can be used.
Wires should be stripped 8 mm to 10 mm at the end. If cables with a larger cross-section
are used, it is recommended to use an intermediate terminal block in the measurement
cabinet between the facility wiring and the device.
Fig. 5.1 Rear panel view of the FP4 device.
Fig. 5.2 Terminals in the FP4W device.