12
CONNECT ELECTRIC POWER
TO AVOID INSTALLATION DIFFICULTIES, DO NOT RUN THE GARAGE DOOR OPENER UNTIL INSTRUCTED TO DO SO.
Connect to properly fused and earth power outlet.
INSTALLATION STEP 8
Mounting the Evercharge Standby Power
Unit (SPU)
If the CM475 Standby power supply unit is part of this
installation it should be installed at this time.
• The SPU can be mounted to either the ceiling or a wall
within 3' (.9 m) of the opener.
• Position the SPU as desired to a structural support
(ceiling joist or wall stud).
• Attach the SPU to the support using the mounting holes
on either side of the SPU.
• Secure the SPU using the 1-1/2" lag screws (2) provided
with the SPU unit.
• Connect the SPU cord into the connector on the bottom
of the opener.
• Follow all instructions included with the CM475 unit to
test for proper operation and testing of the SPU.
SPU Cord
Connector
CM475 EverCharge
Standby Power Unit
TM
USING THE MULTI-FUNCTION DOOR CONTROL
THE MULTI-FUNCTION DOOR CONTROL
Press the push bar to open or close the door. Press again to reverse
the door during the closing cycle or to stop the door while it's
opening.
Light feature
The Light function is not available with the
MJ3800.
Lock feature
Designed to prevent operation of the door from hand-held transmitters whilst still allowing the door to open and close
from the Door Control, the Outdoor Key Switch and the Keyless Entry Accessories. To activate, press and hold the Lock
button for 2 seconds.
To turn off, press and hold the Lock button again for 2 seconds. The Lock feature will also turn off whenever the “learn”
button on the opener panel is activated.
Note: This feature does not operate the Powered door lock.
LO CK
LIG HT
Actuator
Button
LED Indicator
light
LIGHT
LOCK
