Your door opener has already been programmed at the factory to operate with your hand-held transmitter. The
door will open and close when you press the large centre button.
Below are instructions for programming your opener to operate with additional Security
+
transmitters.
1. Press and hold button you wish
to program to the opener.
2. The orange LED (indicator light)
will flash to indicate it is
receiving signal from the
transmitter.
3. Press and release the orange
button. The LED turns off
(approx. 2 sec).
To Add or Reprogram a Hand-held Transmitter
USING THE “LEARN” BUTTON
WIRELESS PROGRAMMING
1
3
To Erase All Codes From
Opener Memory
To deactivate any unwanted
transmitter, first erase all codes:
Press and hold the orange “learn”
button on opener until the learn
indicator LED goes out
(approximately 6-9 seconds).
Note:All previous codes are now erased.
Reprogram each transmitter or keyless entry you
wish to use.
18
3-Button Transmitters
If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on
any 3-button transmitter or mini-transmitter can be
programmed to operate other Merlin Professional garage
door openers or gate openers.
C943
C945
Figure 1
1
2
3
