Mercedes-Benz Mercedes-AMG GT 2015, Руководство пользователя

Страница: 293 / 317

used incorrectly, it could tip over while the
vehicle is raised.
R
the jack is designed only to raise and hold
the vehicle for a short time while a wheel
is being changed. It is not suitable for per-
forming maintenance work under the vehi-
cle.
R
avoid changing the wheel on uphill and
downhill slopes.
R
before raising the vehicle, safeguard it from
rolling away by applying the parking brake
and positioning wheel chocks. Do not
release the parking brake while the vehicle
is raised.
R
the jack must be placed on a firm, flat and
non-slip surface. On a loose surface, a
large, flat load-bearing underlay must be
used. On a slippery surface, a non-slip
underlay must be used, e.g. rubber mats.
R
do not use wooden blocks or similar
objects as a jack underlay. Otherwise, the
jack will not be able to achieve its load-
bearing capacity due to the restricted
height.
R
make sure that the distance between the
underside of the tyres and the ground does
not exceed 3 cm.
R
never place your hands or feet under the
raised vehicle.
R
do not lie under the vehicle.
R
do not start the engine when the vehicle is
raised.
R
do not open or close a door or the tailgate
while the vehicle is raised.
R
make sure that no persons are present in
the vehicle when the vehicle is raised.
Vehicles with hub caps: the hub cap covers
the wheel bolts. Before you can unscrew the
wheel bolts, you must remove the hub cap.
X
To remove: take socket ; and wheel
wrench = from the vehicle tool kit
(
Y
page 263).
X
Position socket ; on hub cap : .
X
Attach wheel wrench = to socket ; and
loosen hub cap : anti-clockwise.
X
Remove hub cap : .
X
To fit: before fitting, check hub cap : and
the wheel area for soiling and clean if nec-
essary.
X
Put hub cap : in position and turn until it is
in the right position.
X
Position socket ; on hub cap : .
X
Attach wheel wrench = to socket ; and
tighten hub cap : .
The tightening torque must be 25 Nm.
i
Note that the hub cap should be tight-
ened to the specified torque of 25 Nm.
Mercedes-Benz recommends that you have
the hub cap fitted at a qualified specialist
workshop.
X
Using wheel wrench = , loosen the bolts on
the wheel you wish to change by about one
290
Changing a wheel
Wh
eels
and
ty
re
s