Mercedes-Benz Mercedes-AMG GT 2015, Руководство пользователя

Страница: 243 / 317

objects are present within the sweep of the
door or gate.
X
Set the Start/Stop button to key position 2
(
Y
page 122).
X
Get out of the vehicle.
X
Press the programming button on the door
drive unit.
Usually, you now have 30 seconds to ini-
tiate the next step.
X
Get into the vehicle.
X
Press previously programmed button ; ,
= or ? of the integrated garage door
opener until the door closes.
The rolling code synchronisation is then
complete.
Problems when programming
If you have problems when programming the
integrated garage door opener, please note
the following:
R
Check the transmitter frequency used by
garage door drive remote control A and
whether it is supported. The transmitter
frequency can usually be found on the back
of the garage door drive remote control.
R
Replace the batteries in garage door
remote control A . This increases the like-
lihood that garage door remote control A
will transmit a strong and precise signal to
the integrated garage door opener in the
rear-view mirror.
R
When programming, hold remote control
A at varying distances and angles from the
button which you are programming. Try var-
ious angles at a distance between 5and
30 cm or at the same angle but at varying
distances.
R
If there is another remote control for the
same garage door drive, perform the pro-
gramming steps again using this remote
control. Before performing these steps,
make sure that new batteries have been
fitted in garage door drive remote control
A .
R
Note that some remote controls transmit
only for a limited period (the indicator lamp
on the remote control goes out). Press but-
ton B on remote control A again before
transmission ends.
R
Align the aerial cable of the garage door
opener unit. This can improve signal recep-
tion/transmission.
Opening or closing the garage door
Once programmed, the integrated garage
door opener will assume the function of the
garage door system's remote control. Please
also read the operating instructions for the
garage door system.
X
Set the Start/Stop button to key position 2
(
Y
page 122).
X
Press button ; , = or ? which you have
programmed to operate the garage door.
Garage door system with a fixed code: indi-
cator lamp : lights up green.
Garage door system with a rolling code:
indicator lamp : flashes green.
The transmitter will transmit a signal for as
long as the button is pressed. The trans-
mission is halted after a maximum of ten
seconds and indicator lamp : lights up
yellow.
X
Press button ; , = or ? again if neces-
sary.
Clearing the memory
Make sure that you clear the memory of the
integrated garage door opener before selling
the vehicle.
X
Set the Start/Stop button to key position 2
(
Y
page 122).
X
Press and hold buttons ; and ? .
The indicator lamp initially lights up yellow
and then green.
X
Release buttons ; and ? .
The memory of the integrated garage door
opener in the rear-view mirror is cleared.
240
Features
Stowing
and
features