Flat tyre
325
X
Make sure that the base of the jack is posi-
tioned directly under jacking point
1
.
X
Turn crank
3
until the tyre is raised a max-
imum of 3 cm from the ground.
X
Unscrew the uppermost wheel bolt com-
pletely.
1
Centring pin
X
In place of the wheel bolt, screw centring
pin
1
from the vehicle tool kit into the
thread.
X
Unscrew the remaining wheel bolts fully.
!
Do not place wheel bolts in sand or on a
dirty surface. This could cause damage to
the bolt and wheel hub threads.
X
Remove the wheel.
Fitting a new wheel
G
Risk of accident
Replace damaged or corroded wheel bolts.
Never oil or grease wheel bolts.
G
Risk of accident
If a wheel hub thread is damaged, you must
not drive the vehicle any further. Consult a
qualified specialist workshop which has the
necessary specialist knowledge and tools
to carry out the work required. Mercedes-
Benz recommends that you use a
Mercedes-Benz Service Centre or Service
24h for this purpose. In particular, work rel-
evant to safety or on safety-related systems
must be carried out at a qualified specialist
workshop.
G
Risk of accident
Only use wheel bolts that have been
designed for the wheel and the vehicle. For
safety reasons, Mercedes-Benz recom-
mends that you only use wheel bolts which
have been approved for Mercedes-Benz
vehicles. Other bolts could work loose.
Do not tighten the wheel bolts completely
while the vehicle is still jacked up. The vehi-
cle could topple off the jack.
Practical advice
211_AKB; 2; 5, en-GB
mkalafa,
Version: 2.9.4
2008-02-29T16:57:07+01:00 - Seite 325
Z
Dateiname: 6515_3416_02_buchblock.pdf;
preflight