Mercedes-Benz Actros, Руководство по эксплуатации

Страница: 73 / 418

The MirrorCam system automatically switches to
standby mode in the following situations:
R
Two minutes after the ignition has been
switched off.
R
Two minutes after the Ï button was last
pressed after the ignition was switched off.
% Ten seconds before the system changes to
standby mode, the Ø symbol is shown in
the display.
The system is reactivated out of standby mode in
the following situations:
R
The Ï button is pressed.
R
A door is opened.
%
When the system is activated out of standby
mode, an image is available to the driver in
the display within one second.
The system is automatically deactivated after five
minutes in standby mode.
Adjusting the field of vision
Adjusting the back edge of the semitrailer/
trailer
After switching on the ignition or after changing
the semitrailer/trailer, adjustable distance line
1 shown in the display can be moved to the
back edge of the trailer/semitrailer.
For a more exact setting, it is recommended to
place an object at the end of the vehicle on the
ground and align the line with it.
Requirements:
R
The Õ symbol is shown in the display.
R
The vehicle speed is less than 10 km/h.
R
The automatic field of vision adjustment func‐
tion is not active.
#
Press the upper or lower area of the
Í
button to move line 1 shown in the display.
The line in the display flashes.
#
To store the setting: press the
Í
button
right or left.
The line shown in the display stops flashing.
The setting is stored for both sides.
%
The selected setting remains stored even
after switching off the ignition. This way, the
back edge must be reset only if the overall
length is changed, e.g. by a different semi‐
trailer/trailer or if there is an overhanging
load.
% The semitrailer/trailer back edge is hidden
when semitrailer tracking is active or if the
field of vision is manually set.
% If manoeuvring view has been activated, the
semitrailer/trailer back edge is displayed
elongated for better orientation.
Manual field of vision adjustment
The driver is able to move the field of vision
shown in the upper section of the display up,
down, left or right.
#
To adjust the field of vision manually:
press the
|
button for the left-hand dis‐
play or the
~
button for the right-hand dis‐
play.
The indicator lamp on the respective button
will light up.
#
Using the
Í
button, move the field of
vision.
If the field of vision shown in the display devi‐
ates from the legally prescribed field of vision
(basic setting), the Ô symbol (red) is
shown in the display.
% If the manoeuvring view is activated, both
fields of vision shown in the display are
moved.
% The distance lines are hidden if the field of
vision was set manually ( / page 73).
#
To reset the field of vision to the basic set‐
ting: press the
|
button for the left-hand
display or the
~
button for the right-hand
display.
The indicator lamp on the respective button
will light up.
#
Press and hold the
Ï
button for approx‐
imately two seconds.
The field of vision is reset to the basic setting.
When the legally prescribed field of vision is
shown in the display again, the Ô symbol
(green) flashes in the display for five seconds
and then goes out.
Driver cockpit 71