Menvier Security TS790+, Инструкция по установке и программированию

Страница: 29 / 70

TS790+ & TS900+ Installation Manual Engineer’s Menu 1
25
Panel Outputs [1.1]
Outputs 1 - 4 on the control panel and remote
keypad outputs 5 - 8 can be programmed to
any of the output types shown on page 25.
Panel Outputs Flowchart
Digicom Outputs [1.2]
The digicom outputs 1 to 8 and plug-on pins 1
to 7 on the control panel PCB can be
programmed to any of the output types shown
on page 25. In addition, all outputs can be
inverted,
see “Configuration option 19” on
page 36.
Digi Outputs Flowchart
Digicom Channels [1.3]
The 8 plug-on digicom channels can be
programmed to any of the output types shown
on page 25.
Digi Channels Flowchart
Programmable Output Types
No/Type Description
000
Bell On
Activates when the main Bell trigger is
on and deactivates at the end of the
Bell Duration time or when the alarm
is cancelled by the user.
001
Strobe On
Activates when the Strobe trigger is
on, and deactivates when the alarm
is cancelled by the user.
002
Switch 12V
Activates when the system is set and
deactivates when an alarm occurs or
the system is unset. This output is
normally used for latching detectors.
003
Detector Reset
Normally active at all times and
deactivates for 3 seconds when a
valid passcode is entered prior to
setting the system. This output is
normally used for detector that
required power to be removed in
order to reset them, e.g., smoke
detectors.
004
Walk Test
Activates when the “Walk Test” option
is selected and deactivates when the
“Walk Test” option is finished.
005
Alarm
Activates when an intruder alarm is
detected and deactivates when the
alarm is reset or aborted.
006
P.A.
Activates when a PA alarm is
detected and deactivates when the
alarm is reset.
007
Fire
Activates when a Fire alarm is
detected and deactivates when the
alarm is reset.