Meler MACRO FOAM Series, Инструкция по эксплуатации, Страница: 68 / 88

FOCKE MELER GLUING SOLUTIONS, S.A.
5-4
MAINTENANCE
Tank filter
At the manifolds input there is a coarse filter inside the tank itself. This filter
acts as a first step stoping dirty and parts from the outside.
This filter includes an output to empty the tank for cleaning it or changing the
adhesive. Therefore to clean the filter the tank must to be empty previously.
To remove the filter:
1. Remove four screws that fix the assembly.
2. Take out the filter using the holding ring at the end of the filter.
3. Clean the grid of dirty and burnt adhesive.
4. Replace the o-ring if it is damaged.
5. Put the assembly into the tank fixing it with the four screws.
Cleaning the tank
The hot-melt tank must be cleaned on occasion to maintain its fusion and
anti-adherence properties. The tank is covered on the inside with PTFE and
inclined enough to aid unloading the hot-melt and to avoid it from being
retained inside when consequential burning occurs.
Furthermore, when adhesives are mixed, reactions may occur between them,
causing a degeneration and thus problems in unloading in the direction of the
pump.
Therefore, it is recommended to clean the deposit every time that:
• A change is made to a different type of hot-melt.
• Too much burnt material is generated in its interior.
Changing adhesive type
1. Use up as much of the adhesive as possible.
If it is necessary to unload the adhesive without having used it up as much as
possible, follow the instructions in the section ‘Emptying the tank’.
2. Clean the remains of hot-melt adhesive on the inside of the tank.
Warning: Use appropriate protective equipment for high temperatures.
3. Add the appropriate type and quantity of the new adhesive, wait for it
to melt and pump at least one full tank through the system (hoses and
applicators).