Meler MACRO FOAM Series, Инструкция по эксплуатации, Страница: 42 / 88

FOCKE MELER GLUING SOLUTIONS, S.A.
4-8
MELTER OPERATION
The value shown corresponds to the percent decrease in the real
temperature compared to the set point temperature that will occur
when this function is activated.
7. Use the right arrow to go to the next display where delay time value
appears.
8. Use the up-down arrow to select the desired value (between 0 and 60
min).
Attention: in order to ensure the proper flow of the
adhesive, it is recommended not set a value less than
10 minutes.
9. Use the right arrow to advance to the next screen, where the level
detector activation/deactivation is found.
10. Use the up-down arrow to select the desired value (ON/OFF). When
OFF is selected, neither the on-screen display nor the external signal
activation will be operational. If ON is selected, when the level of hot-
melt is low the alarm (n - - - ) will be displayed on the screen and the
external signal contact will be activated.
11. Use the right arrow to return to the initial parameter.
12. For any parameter, the left arrow may be used to exit the special menu
and display the tank temperatures once again.
To record any parameter, you must always move to the next parameter, using
the right arrow.
Setting the clock
Macro Foam system series melters are equipped with a weekly programmable
system controlling equipment connection and disconnection and activating
and deactivating the standby function.
Before programming these functions, it is necessary to introduce into the
control unit data corresponding to the day and hour used to execute these
programs.
Programming the current day and hour
1. Press the button with the clock symbol.
A ‘0’ will appear on the display, indicating the program for current day
and hour information.
2. Press the button with the clock symbol once again.
o f f o f f nn
- - - - - -
nn
1 0 1 0
ƒƒ
1 6 0 1 6 0 1 6 0 1 6 0
0 0